Saved Loop - Rane SEVENTY Guia Del Usuario

Saved Loop

In Saved Loop Mode, each pad triggers a loop
previously saved in your software.
To enter Saved Loop Mode, press Saved Loop so
that it lights dark blue.
To play a loop, press a lit Pad. Each deck's eight
pads will correspond to Saved Loops 1–8 in your
software, and the color of each pad will correspond to
the color assigned to each loop in your software.
To restart the currently playing loop, press Shift and the corresponding lit Pad.
To halve or double the length of the loop, press the Parameter / buttons.
To shift the loop backward or forward, press Shift and the Parameter / buttons.
Flip
If you have purchased the Serato Flip Expansion
Pack, you can access the Flip control by pressing
Saved Loop so that it lights white. If you have not
purchased the Flip Expansion Pack, this will be
available as a Custom Pad mode.
In this mode, unlit pads have no Flip assigned to
them; pads lit blue have a Flip assigned but are not
playing; pads lit orange have a Flip assigned and are
currently playing.
To assign a Flip to a pad, press an unlit pad (1-6).
To play an assigned Flip, press the corresponding blue lit pad (1-6).
To immediately stop playback of a Flip, hold Shift and then press the corresponding orange lit pad (1-
6).
To start Flip recording, press the left Parameter  button.
To return to the start of the selected Flip, press the right Parameter  button.
To toggle the Flip Slot Loop, hold Shift and then press the left Parameter  button.
To toggle the Flip Slot on and off, hold Shift and then press the right Parameter  button.
Roll
In Roll Mode, each pad triggers a momentary loop roll. Releasing the pad stops the loop roll and resumes
normal playback where the playhead would be if you had not triggered the loop roll (i.e., as if the track had
been playing forward the whole time).
Note: Disable Show Beat Jump Controls in the Serato Setup menu to access 8 loop rolls at once. You
can also view and edit the set loop sizes in the software.
To enter Roll Mode, press Roll so that it lights aqua.
To trigger a loop roll, press and hold a Pad.
To change which eight lengths for loop rolls are shown (in the software), press either of the Parameter
/ buttons. The pad layout will shift to match it.
To shift the loop roll backward or forward, press Shift and the Parameter / buttons, respectively.
1 2
Saved Saved
Loop 1 Loop 2
5 6
Saved Saved
Loop 5 Loop 6
Flip 1 Flip 2
Flip 5 Flip 6
3 4
Saved Saved
Loop 3 Loop 4
7 8
Saved Saved
Loop 7 Loop 8
Flip 3 Flip 4
No No
Function Function
13