Connecting To Power Supply - Balluff BMD 1L Serie Manual Del Usuario

Connection technology
Connection procedure
4

Connecting to power supply

4.1 Connecting
loaded terminals in the housing.
Connection to the display and adjustment module or to the interface
Information:
and pull it out. When reinserting the terminal block, you should hear it
snap in.
Proceed as follows:
1. Unscrew the housing lid
ing it slightly to the left
plug
5. Insert the cable into the sensor through the cable entry
Fig. 6: Connection steps 5 and 6 - Single chamber housing
6. Insert the wire ends into the terminals according to the wiring plan
Information:
the terminal closes again.
4 Connecting to power supply
-
-
9