Wiring Plan, Single Chamber Housing - Balluff BMD 1L Serie Manual Del Usuario

4 Connecting to power supply
Electronics and terminal
compartment
10
"Technical data - Electromechanical data".
7. Check the hold of the wires in the terminals by lightly pulling on
them
9. Tighten the compression nut of the cable entry gland. The seal
ring must completely encircle the cable
10. Reinsert the display and adjustment module, if one was installed
11. Screw the housing lid back on
4.2

Wiring plan, single chamber housing

4...20mA
+
( )
1
Fig. 7: Electronics and terminal compartment - single chamber housing
1 Voltage supply, signal output
2 For display and adjustment module or interface adapter
3 For external display and adjustment unit
4 Ground terminal for connection of the cable screen
1 2
5 6 7 8
(-)
2
3
4