Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Switching on for the first time
Plug into AC power by following the instructions from the previous 'Connecting AC
DE
adapter' section. Press the STANDBY
FR
STANDBY indicator will light up to full brightness. To turn the turntable off, press the
STANDBY
button again and the STANDBY indicator will change to half brightness.
ES
Switching between Phono/USB sources
JP
After turning on the turntable, rotate the SOURCE selector to switch between
different sound sources.
IT
Adjusting sound volume level
After turning on the turntable, turn the VOLUME CONTROL dial to adjust the level of
sound volume.
Power management function
The turntable will automatically go into standby mode after 15 minutes if it is not
being used. To resume operation, simply press the STANDBY
turntable back on.
LISTENING TO A RECORD
1. Lift the DUST COVER all the way up until it stops. The cover will stay open.
2. Remove the tie-wrap from the TONE ARM (when using for the first time).
3. Remove the white protective needle cover by gently pulling it forward.
4. Release the tone arm HOLD DOWN CLIP by gently pushing to the right. This will
unlock the TONE ARM from its arm rest.
Note:
Re-lock the HOLD DOWN CLIP when moving the turntable to another location.
button to turn on the turntable and the
button to turn the
03
Turntable operation
1. Rotate the SOURCE selector to PHONO mode.
2. Set the SPEED selector to the correct position (33, 45, or 78 RPM).
3. Place the record on the turntable.
4. Lift the TONE ARM CONTROL lever and move the TONE ARM to the desired starting
point over the record.
5. Lower the TONE ARM CONTROL lever and the TONE ARM will move down and
music will start playing.
6. Turn the VOLUME CONTROL dial to adjust the volume to the desired level.
7. Slide the AUTO STOP CONTROL switch to choose the auto stop function.
8. At the end of the record, the TONE ARM will stop automatically. You should return
the TONE ARM to the TONE ARM REST manually.
Note:
When playing records, sound output of the built-in amplifiers is limited to avoid
feedback and rumble. This is normal. Keep the volume as low as possible on the
turntable and instead increase the volume on the external amplifier.
Adapter for 45 RPM (Accessory)
This adapter allows you to play 45 RPM records.
1. Gently place your 45 RPM record onto the turntable.
2. Place the 45 RPM ADAPTER over the spindle.
3. Follow normal turntable operation steps to play your record.
LISTENING TO A USB DEVICE
USB device playback (support MP3 file)
1. Rotate the SOURCE selector to USB mode.
2. Insert the USB device into the USB port and it will start playing.
3. Turn the VOLUME CONTROL dial to adjust the volume to the desired level.
4. When removing the USB device, first press the USB PLAY/PAUSE
playback.
button to stop
04
EN
DE
FR
ES
JP
IT
Publicidad
