Water Supply Requirements - GE WSSH300G2WW Manual De Propietario

Installation Instructions
ELECTRICAL REQUIREMENTS
Read these instructions completely
and carefully.
CIRCUIT - Individual, properly polarized and grounded
15-amp branch circuit fllsed with 15-amp time-delay fllse
or circuit breaker:
POWER SUPPLY- 2-wire, with gro/md, 120wolt, single-
phase, 60-Hz, Mternating CmTent.
OUTLET RECEPTACLE - Properly grounded
3-prong receptacle to be locamd so the power SUl)ply cord
is accessible when the washer is in an installed position.
@
@
GROUNDING REQUIREMENTS
A WARNING: connection ofthe
equipment g_x)tmding conductor can result in a risk
(ff electrical shock. Check with a licensed electrician
flyou are in doubt as to whether the appliance is
propedy gromMed.
1, Tile washer MUST be grotmded. In tile event oI
malflmction or breakdown, grounding will reduce
the risk ()t electrical shock by pr(Mding a path of least
resistance for electrical cmTent.
Since v()m" washer is equipped with a power supply
cord having an equipment-gromMing conductor and
a gromMing plug, the plug MUST be plugged into an
al)l)ropriate , coppe_vired receptacle that is i)roperly
installed and gro/mded in accordance with all local
codes and ordinances or in the absence ot local codes,
with the National Electrical Codes, ANSI/NFPA 70
(latest edition)./t in doubt, call a licensed electfidan.
DO NOT etlt off- or alter tile grotmding prong on tile
power suI)ply cord. In situations where a two-slot
receptacle is present, it is the owner's responsibility to
have a licensed electrician replace it with a properly
grounded three-prong gromMing-Ql)e receptacle.
WATER SUPPLY REQUIREMENTS
Hot and cold water fimcets MUST be installed within
42 inches (] 07 cm) of yore" washer's water inlet. The
fimcets MUST be 3/4" (1.9 cm) garden hose-t)'l)e so
inlet hoses can be connected. Water pressm'e MUST be
bet_ven 10 and 120 pounds per square inch (maMmum
tmbalanced pressm'e, hot vs. cold, l 0 psi.) Yimr _;_ter
department can a(Mse )'ou of yore" water pressure.
The hot water temperature should be set to deliver
water at 120 ° to 140°F (48°-(;0°(:).
DRAIN REQUIREMENTS
1. Drain capable ot eliminating 17 gals (64.3 i,)
per minute.
2. A standpipe diameter of 1 1/4" (3.18 cm) minim urn.
3. Tile standpipe height above tile floor
should be:
Minimum height: 24" (61 cm)
Maxim umh eight: 96" (244 cm )
o oo
J
_REAR
96"
(244cm)
Max.
NOTE: Tile drain hose am_ched to tile washer can reach
a 90" (229 cm) high standpipe. For a higher standpipe,
contact an authorized parts distributor: If tile drain is less
than 24" (61 cm), install a siphon break kit, available at
yore" local hardware store.
14