Troubleshooting - Schneider Airsystems SSP-SAV Manual De Instrucciones

GB
SSP
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A No material or
insufficient mate-
rial sprayed
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 10
Cause
Nozzle (item 11) blocked
Nozzle (item 11) not adjusted
or setting incorrect
Nozzle (item 11) or Venturi
nozzle worn
Ventilation (item 15) on blast-
ing abrasive vessel blocked
Air pipe (item 07) on material
suction hose blocked
Moist air
Blasting abrasive too coarse
Hose diameter too small
Compressor output too small
Working pressure (flow pres-
sure) too low
Remedy
Clean nozzle dry or replace
***
Adjust nozzle
Replace nozzles
Schneider Druckluft GmbH or
your local service partner.
Clean ventilation dry or replace
****
cover
Clean air pipe dry or replace
Install a water separator or com-
pressed air dryer
Use blasting abrasive with a
maximum grain size of 0.8 mm
Use correct hose diameter
Use different output
*
rating
Increase working pressure (flow
pressure) Observe
working pressure
or contact
*
*
maximum
*