Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
17. KEEP HANDS AND FEET AWAY FROM
FIRING HEAD DURING USE.
Never place your hands or feet closer
than 8 inches (200 mm) from the firing
head.
A serious injury can result if the fasteners
are deflected by the workpiece, or are
driven away from the point of entry.
18. PLACE
NAILER
WORKPIECE.
Do not drive fasteners on top of other
fasteners or with the Nailer at too steep
of an angle; the fasteners can ricochet
and hurt someone.
19. BE CAREFUL OF DOUBLE FIRE DUE TO
RECOIL.
If the push lever is unintentionally
allowed to re-contact the workpiece
following recoil, an unwanted fastener
will be driven.
In order to avoid this undesirable double
fire,
1) do not push the Nailer on the
workpiece with strong force;
2) take the Nailer completely away from
the workpiece using recoil, and keep
the push lever away from the
workpiece until the next desirable
shot; and
3) pull the trigger and release it QUICKLY
when
performing
operation (trigger fire).
20. DO NOT DRIVE FASTENERS INTO THIN
BOARDS OR NEAR CORNERS AND
EDGES OF WORKPIECE.
The fasteners can be driven through or
away from the workpiece and hit
someone.
21. NEVER DRIVE FASTENERS FROM BOTH
SIDES OF A WALL AT THE SAME TIME.
The fasteners can be driven into and
through the wall and hit a person on the
opposite side.
SAFETY
WARNING
PROPERLY
ON
intermittent
— Continued
22. CHECK FOR LIVE WIRES.
Avoid the risk of severe electrical shock
by checking for live electrical wires that
may be hidden by walls, floors or ceilings.
Turn off the breaker switch to ensure
there are no live wires.
23. NEVER CARRY NAILER BY HOSE.
24. DO NOT OVERREACH.
Keep proper footing and balance at all
times.
25. NEVER USE NAILER WHICH IS DEFECTIVE
OR OPERATING ABNORMALLY.
If the Nailer appears to be operating
unusually, making strange noises, or
otherwise appears defective, stop using
it immediately and arrange for repairs by
a Hitachi authorized service center.
26. DO NOT DISCONNECT AIR HOSE FROM
NAILER WITH FINGER ON TRIGGER.
The Nailer can fire when reconnected to
an air supply.
27. DISCONNECT AIR HOSE FROM NAILER
WHEN:
1) doing maintenance and inspection;
2) clearing a jam;
3) it is not in use;
4) leaving work area;
5) moving it to another location; and
6) handing it to another person.
Never attempt to clear a jam or repair the
Nailer unless you have disconnected air
hose from the Nailer and removed all
remaining fasteners from the Nailer.
The Nailer should never be left
unattended since people who are not
familiar with the Nailer might handle it
and injure the themselves.
— 6 —
Publicidad
Tabla de contenido
