Technical Data; Ordering Replacement Parts; Troubleshooting - Gardol GE 1500-38 Manual De Instrucciones

Anleitung GE_1500-38_SPK7:_
GB

12. Technical data

Voltage:
Power input:
Motor speed:
Cutting width:
Cutting height adjustment:
Volume of catch bag:
L sound pressure level:
pA
L sound power level:
WA
Vibration at the handlebars:

14. Troubleshooting

Fault
The motor fails to start
The motor performance drops
Cutting is irregular
Important!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is
overloaded and switches on again automatically after a short cooling period.
20
09.02.2007 9:18 Uhr

13. Ordering replacement parts

Please quote the following data when ordering
230 V ~ 50 Hz
replacement parts:
1500 watts
Type of machine
3400 rpm
Article number of the machine
Identification number of the machine
38 cm
Replacement part number of the part required
25-75 mm; 6 levels
For our latest prices and information please go to
40 liters
www.isc-gmbh.info
80 dB(A)
96 dB(A)
≤ 2.5 m/s
2
Possible causes
a) The capacitor is defective
b) There is no electricity at the plug
c) The cable is defective
d) The combined switch/plug is
defective
e) The connectors have become
separated from the motor
or the capacitor
f) The mower is standing in high
grass
g) The mower housing is clogged
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
a) The blade is worn
b) Wrong cutting height
Seite 20
Remedies
a) The mower housing is
clogged Have repaired by
the Customer Service
Center
b) Check the cable and the
fuse
c) Check the cable
d) Have repaired by the
Customer Service Center
e) Have repaired by the
Customer Service Center
f) Start in low grass or on an
area that has already
been mowed; change the
cutting height if necessary
g) Clean the housing so that
the blade moves freely
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
a) Replace or resharpen the
blade
b) Correct the cutting height