Personal Protective Equipment; Before Use; Fitting The Side Handle - Hilti DAG 115-S Manual De Instrucciones

5.6.5 Personal protective equipment

en
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

WARNING
Never use the power tool without the guard.
DANGER
Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
CAUTION
Wear gloves when fitting or removing parts, when
making adjustments or when remedying malfunc-
tions.

6.1 Fitting the side handle

WARNING
The side handle must be fitted for all types of work.
The side handle may be screwed onto the power tool on
the right or left.
6.2 Guard
CAUTION
Adjust the position of the guard to suit the require-
ments of the work being done.
CAUTION
The closed side of the guard must always face the
operator.
6.2.1 Fitting and removing the guard or guard with
cover plate 2
1. Disconnect the supply cord plug from the power
outlet.
2. Fit the guard so that the locating lug engages in the
notch in the spindle collar and then rotate it into the
required working position.
3. Secure the guard by tightening the screw.
22
tion, protective gloves and breathing protection while
the power tool is in use.
4. Screw the side handle onto the right or left side of
the gearing section, depending on how the power
tool will be held when working.
5. To remove the guard from the power tool, follow the
instructions for fitting the guard but carry out the
steps in the reverse order.
6.3 Fitting and removing the disc 4
DANGER
Check that the speed rating printed on the cutting
or grinding disc is equal to or higher than the rated
speed of the power tool.
DANGER
Check the condition of the grinding disc before us-
ing it. Do not use discs that are broken, cracked or
damaged in any way.
NOTE
Diamond discs must be replaced when the cutting or
grinding performance drops significantly. This generally
is the case when the segments reach a height of less
than 2 mm. Other discs must be replaced when the
cutting performance drops significantly or other parts of
the angle grinder (not the disc) come into contact with
the material you are working on. Abrasive discs generally
have to be replaced when the durability date has been
reached.
1. Disconnect the supply cord plug from the power
outlet.
2. Place the clamping flange on the spindle so that the
side with the recess is seated against the spindle
flange (transmission of rotary drive).
3. Fit the insert tool.
4. Screw on the clamping nut and tighten it.
CAUTION Do not press the spindle lockbutton
5.
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
6. Use the wrench to tighten the clamping nut securely
and then release the spindle lockbutton.