Concluding Treatment - Beurer FM 150 Instrucciones De Uso

8. Press „timer" button to switch among three
kinds of timing time which are 10 minutes,
20 minutes and 30 minutes. When start up,
the default is 20 minutes. When the remai-
ning time is 5 minutes, the current time in-
dicator slowly flashes; when the remaining
time is 1 minute, the current time indicator
quickly flashes.
9. In the process of using, if you feel the pres-
sure is too much or not comfortable, press
the „stop" button to stop the treatment.
Note
The device will now start to massage the legs alternately. The legs will never be massaged at the same
time. This is not an indication that the device is faulty.
The device features an automatic switch-off function, which is set to the maximum operating duration of 30 mi-
nutes.
If the batteries are almost flat, the timer LEDs begin to flash from right to left. The device will switch off after a
few seconds and then be in a 30-second stand-by mode. During this time, all 3 timer LEDs light up.

6.2 Concluding treatment

To stop the treatment, you should first switch the device off and then let the air out of the leg cuffs.
Proceed as follows:
1. Switch the device off by pressing the ON/
OFF button on the hand switch. The set
timer LED goes out. The device is now in
standby mode for 30 seconds. During this
time, all 3 timer LEDs will be activated.
2. Remove the air hose from the hand switch
within the 30 second standby mode and in-
sert the air hose into the air outlet (
the side of the hand switch and press the
air outlet button [5]. All 3 timer LEDs flash
at the same time. They go out again when
the process has ended.
) on
20
stop stop
stop
stop stop