Cleaning And Maintenance; Technical Specifications - Toolland VL2001 Manual Del Usuario

 Danger! Do not use cleaning agents which could corrode the light alloy components. Do not clean the saw
blade with combustible liquids.
 Only use saw blades conforming to the technical specifications and EN 847-1. Damaged saw blades may be
hurled away. Do not use saw blades made of high-speed steel (HS or HSS), saw blades with visible damage
or cut-off wheel blades.
11. Storage
 Store the saw so that it cannot be started and nobody can get injured.
 Do not store the saw unprotected outdoors or in a damp environment
12.

Cleaning and Maintenance

 Switch off the machine.
 Wait for saw blade to come to a complete stop.
 Make sure the power supply is disconnected.
 Check that all safety devices are operational again after each service.
 Replace damaged parts, especially safety devices. Only use genuine replacement parts since parts not
tested and approved by the equipment manufacturer can cause unforeseeable damage.
 Repair and maintenance work other than described in this section should only be carried out by qualified
specialists.
13.

Technical Specifications

power supply
power consumption
max. capacity
saw blade
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 05/08/2015
VL2001
230 V~, 50 Hz
2200 W
140 mm
40 cm
34 kg
10 ©Velleman nv