Mixing Jug Assembly; Preparation; Operating The Mixer; Refill Ingredients - Clatronic KM 3645 Instrucciones De Servicio

NOTE:
The knives in the mixing jug are also suitable for the crush-
ing of small quantities of pure ice. However, remember that
this may blunt the knives.
Recommendation:
When preparing drinks with crushed ice, add the ice cubes
while mixing. The ice is crushed during mixing.
• Do not use the blender without ingredients!
• Do not exceed the maximum capacity (1500 ml) as indicat-
ed on the mixing container!
• Froth requires a large capacity. Reduce quantities of
liquids which produce a lot of froth.
• Only turn on the mixer with the lid and the fitted cap.
Secure the lid by turning it a short distance clockwise.
• Do not remove the lid during operation! Wait until the
blade comes to a stop before you open the lid.
• Should you not be satisfied with the mixing results,
proceed as follows:
1. Turn off the appliance.
2. Remove the lid from the blender jug.
3. Loosen any stuck-on ingredients with a dough scraper.
Stir the ingredients with the dough scraper.
4. Remove some of the contents. Process smaller quanti-
ties or add some liquid.

Mixing Jug Assembly

NOTE:
The mixer jug has a mark at the bottom. The symbols
and can be found on the motor housing.
1. Align the mixer jug marking with the
2. Turn the mixing bowl towards
WARNING:
• Always disconnect the mains plug before you remove the acces-
sories and clean the appliance!
• Do not immerse the motor housing in water for cleaning in any
case. This may lead to electric shock or fire.
• Some parts of the accessories are very sharp. There is risk of injury!
CAUTION:
• Do not use a wire brush or other abrasive utensils for

cleaning.

• Do not use aggressive or abrasive cleaning agents.
50
KM3645_IM

Preparation

1. Cut all ingredients in small pieces.
2. Fill the ingredients into the blender jug. Observe the
3. Fit the lid onto the blender jug.
4. Close the lid with the stopper (18).

Operating the Mixer

Any speed can be selected with the control knob.
If the blender jug is very full or if it contains a foaming liquid,
always start with step 1.

Refill Ingredients

1. Switch the appliance off. Wait until the blade comes to a
2. Fill in ingredients or spices through the stopper opening.
3. Close lid and stopper opening again.
4. Continue operation.

Stop Operation

1. Switch the appliance off. Wait until the blade comes to a
2. Disconnect from mains power supply.
3. Turn the mixing bowl in the direction of
4. Remove the lid before pouring out the contents.
5. Clean all used parts as described under "Cleaning".
symbol.
. It latches into place.
Cleaning

Motor Housing

Clean the housing only with a damp cloth and a squirt of
washing-up liquid. Dry with a cloth.

Accessories of the Kitchen Appliance

maximum capacity.
stop.
stop.
housing.
IMPORTANT NOTE:
Do not store citrus juices or acidic foodstuffs in metal
containers.
WARNING: Risk of injury!
Some parts of the accessory are very sharp!
from the motor
06.06.16