Mixing Jug Assembly; Preparation; Operating The Mixer; Refill Ingredients - Clatronic KM 3646 Instrucciones De Servicio

3. Loosen any stuck-on ingredients with a dough scraper.
Stir the ingredients with the dough scraper.
4. Remove some of the contents. Process smaller quanti-
ties or add some liquid.

Mixing Jug Assembly

NOTE:
The mixer jug has a mark at the bottom. The symbols
and can be found on the motor housing.
1. Align the mixer jug marking with the
2. Turn the mixing bowl towards . It latches into place.

Preparation

1. Cut all ingredients in small pieces.
2. Fill the ingredients into the blender jug. Observe the
maximum capacity.
3. Fit the lid onto the blender jug.
4. Close the lid with the stopper (13).

Operating the Mixer

Any speed can be selected with the control knob.
If the blender jug is very full or if it contains a foaming liquid,
always start with step 1.
WARNING:
• Always disconnect the mains plug before you remove the acces-
sories and clean the appliance!
• Do not immerse the motor housing in water for cleaning in any
case. This may lead to electric shock or fire.
• Some parts of the accessories are very sharp. There is risk of injury!
CAUTION:
• Do not use a wire brush or other abrasive utensils for

cleaning.

• Do not use aggressive or abrasive cleaning agents.

Motor Housing

Clean the housing only with a damp cloth and a squirt of
washing-up liquid. Dry with a cloth.

Accessories of the Kitchen Appliance

WARNING: Risk of injury!
Some parts of the accessory are very sharp!
KM3646_IM

Refill Ingredients

1. Switch the appliance off. Wait until the blade comes to a
stop.
2. Fill in ingredients or spices through the stopper opening.
3. Close lid and stopper opening again.
4. Continue operation.

Stop Operation

1. Switch the appliance off. Wait until the blade comes to a
stop.
symbol.
2. Disconnect from mains power supply.
3. Turn the mixing bowl in the direction of
housing.
4. There are two ways to pour out the contents of the mixing
bowl:
• You can pour out the contents with the lid closed. Turn
the lid so that the
marking of the handle.
• Take the lid off completely and pour the contents out.
5. Clean all used parts as described under "Cleaning".
IMPORTANT NOTE:
Do not store citrus juices or acidic foodstuffs in metal
containers.
Cleaning
CAUTION:
The attachments are not suitable for dishwasher. Heat
and aggressive cleaning agents may warp or discolour the
attachments.
• You may clean all other components that have come in
contact with food in a bowl of hot water.
• Rinse with clean water and dry thoroughl
• Traces of dye-rich foods (e.g. carrots) are best removed
with cooking oil.

Blender Accessories

NOTE: Pre-Cleaning
Fill the blender jug half with water and run the appliance for
approx. 10 seconds. Dispose of the liquid.
from the motor
symbol is positioned on the
49
02.06.16