Using The Appliance - Profi Care PC-BS 3040 Manual De Instrucciones

Crevice and Brush Nozzle (21)
NOTE: Folding "2 in 1" nozzle
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
• Crevice nozzle:
For vacuuming dirt from corners, joints and small gaps.
• Brush nozzle:
For removing dirt gently from slits in upholstery and mat-
tresses. Also suitable for removing dust from sensitive
surfaces such as furniture or curtains.
Turbo Brush
The turbo brush is equipped with a rotating roller brush
powered by the air stream. It is particularly suitable for ab-
sorbing hair, threads and lint on upholstery. To absorb hair
better, pay attention to the position of the brush attachment.
The brushes must be folded down. You can fasten or loosen
the attachment with the locking mechanism ( ) on the right
side of the brush roller.
CAUTION:
Do not use the turbo brush on sensitive smooth floors
such as parquet, laminate or similar.
The surface could be damaged.
Mains Cable
Pull the mains cable from the cable compartment. The cable
compartment is located at the back of the appliance below.
CAUTION:
• Pull out the cable up to the maximum length indicated
with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the help of
the cable winding button back to the yellow mark.
Electrical Connection
• Before connecting the plug to the wall socket, check
whether the mains voltage is correct. Refer to the infor-
mation on the rating plate of the appliance.
• Connect the appliance to a certified wall socket only.
38
PC-BS3040_IM

Using the Appliance

1. Insert the mains plug into a correctly installed power
socket.
2. Turn the appliance on by the on / off switch by pressing
down the button.
3. Set the "carpet / hard floor" switch, depending on the floor
covering.
4. Adjust the suction power with the suction power control.
5. Vacuum at a steady speed. There is no need to exert
pressure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
Air Slide
Open the air slide on the hose handle in
order to regulate the airflow or to clear any
particles sticking to the nozzle.
Switching Off and Winding Up the Mains Cable
1. Turn the vacuum cleaner off by the on / off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Maintenance
Emptying the Dust Collector
Empty the dust collector once the collected dirt reaches the
MAX marking.
1. Disconnect the mains plug from the wall socket.
2. Press the button (10) to release the dust collector.
Remove the dust collector.
3. Empty the dust collector over a dustbin. Press the latch
on the dust container to open the bottom plate. (Page
4, Fig. B).
4. Then close the base plate again.
5. Attach the dust collector to the appliance. First position
it at the bottom of the appliance and then secure it with
the hook on top.
6. Check that the position of the dust collector is secure by
briefly lifting the appliance at its carrying handle.
Filters
Your appliance features 4 filters. The common dust bag
system has been replaced by a transparent dust collector.
The higher flow speed of the collector allows for heavy dirt
and smallest floating particles to be separated from the
"sucked-in air".
It is thus not necessary to buy dust bags.
The filters must be cleaned regularly.
12.06.19