Fitting The Battery - Hilti SF 2-A Manual De Instrucciones

6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting it in the corresponding charger.
Information about charging can be found in the operating instructions for
the charger.
Lithium-ion batteries are ready for use even when only partially charged.

6.3 Fitting the battery

CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
position). Use only the Hilti batteries approved for use with this power
tool.
CAUTION
Before inserting the battery in the power tool, check to ensure that
the battery terminals and the contacts in the power tool are free from
foreign objects.
1. Push the battery into the power tool from the front, as far as it will go,
and until it is heard to engage with a click.
2. CAUTION A falling battery may present a risk of injury to yourself
and others.
Check that the battery is seated securely in the power tool.
6.4 Removing the battery
1. Press the release button.
2. Pull the battery out of the tool towards the front.
6.5 Transport and storage of battery packs
Remove the battery from the tool before transport or storage. Make sure that
the battery contacts are not short-circuited. Remove loose metal items such
as screws, nails, clamps, loose screwdriving bits, wires or metal cuttings
and chips from the toolbox or transport container, or prevent these items
from coming into contact with the battery.
Observe national and international transport regulations when shipping
battery packs (transportation by road, rail, sea or air).
Printed: 04.12.2015 | Doc-Nr: PUB / 5174884 / 000 / 01
2
en
37