Settings; Selecting The Operating Mode; Tool Holder, Attachments - Festool BHC 18 Li-Basic Manual De Instrucciones

LED yellow – lit continu­
ously: battery is flat
LED red – lit continuously:
battery, electronics or mo­
tor temperature has ex­
ceeded the permitted limit
values.
LED red – flashing: Gener­
al fault display, e.g. incom­
plete contact, short circuit,
battery pack faulty, etc.
Further information about the battery
pack and charger can be found in the
corresponding operating manual.
8

Settings

8.1 Changing direction of rotation [1-3]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8.2

Selecting the operating mode

Hammer drilling
Set selector switch [1-5] to hammer
symbol.
Screwdriving/drilling
Set selector switch [1-5] to drill symbol.
9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
9.1 Changing tools [3]
The SDS-plus system clamps drilling
tools in position without requiring a
tool wrench.
CAUTION
Hot and sharp tools
Risk of injury
► Do not use insert tools that are blunt or de­
fective.
► Wear protective gloves.
3
2
Inserting the tool
► Clean the tool shaft and grease lightly.
► Do not retract the release sleeve [3-2], in­
stead turn the tool in the tool adapter[3-1]
until it clicks into position.
► Check that the tool is seated securely.
Removing the tool
► Pull back the release sleeve [3-2] and re­
move the tool.
9.2 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
► Before working with the CENTROTEC tool
chuck, set the selector switch [1-5] to the
drill symbol.
4
1
2
English
3-1
click
1
3-2
click
3
click
4
5
11