Cleaning And Maintenance - ECG MN 103 Manual De Instrucciones

OPERATING INSTRUCTIONS
The correct use of the product signifi cantly improves blood circulation in the legs, which themselves feel
pleasant and warmer for longer (increase in skin temperature). A regular massage bath can help to improve
blood circulation in the legs and indirectly therefore in the entire lower limb area.
The built in heating element under each massage roller maintains the required temperature for the entire
time that the massage machine is turned on using the dial switch.
There are about 400 stimulation points on the area of the massage machine, which like gentle fi ngers
touch your feet and carry out the most eff ective, refreshing and invigorating massage. The effi ciency of the
massage can be controlled by gently increasing or decreasing the pressure of the feet on the massage areas.
Furthermore there are 70 air jets located in the product, which create a warm relaxing bubble bath for your
legs.
Fill the massage machine with warm water (at the required temperature), the volume of water should not
exceed the maximum water level mark. This product is designed only to maintain the temperature of the
added water at a pleasant level but not to heat it up.
Comfortably sit down, place your feet on the massage rollers and using the dial switch set the massage mode
to:
1. warm bath + vibration massage + bubble massage + infra-radiation
If you wish to carry out the foot massage in a warm water bubble bath.
2. warm bath + blowing
If you wish to carry out the foot massage in pleasant warm water.
The aromatic diff user provides pleasant aroma therapy, because the fragrance is optimally dispersed
by the air current. Put a few drops of an aromatic oil on the cotton pillow and then place the pillow on the
aromatic diff user and insert it back. It can also be used as a nail dryer.
3. vibration massage + infra radiation
If you want to massage your feet in a water bath (without temperature control).
0. off
After completing the massage fi rt turn the switch to the position "0", and only then remove your feet and
disconnect the product from the power socket.
Do not forget that you must not stand up in the product!
When pouring in the water tilt the product, e.g. above the bath tub so that the water can run out the spout.

CLEANING AND MAINTENANCE

The massage unit in a health device, not a wash basin. Before the massage wash your feet in clean soft water.
Settled particles clog the air jets and worsen the bubble eff ect.
Before cleaning always pull the power cord out of the socket and wait until the product has completely
cooled down.
After using the massage machine simply rinse out with clean water. Never submerge the entire product
under water!
To clean the surface of the product use a damp cloth. DO NOT USE any chemical cleaning agents / abrasive
cleaning agents.
You can store the massage machine only after the main switch has been turned off , it is disconnected from
the power socket, is without water and after it has completely cooled down. Before storage wind the power
cord around the winding holder.
GB
21