Bionaire BU6000 Manual De Instrucciones página 6

Control Panel
ON /
Low Mist
Standby
Control
Knob
1. Rotate the control knob clockwise from the off
position to the position between Low
& High mist range to start the humidifier.
The indicator light will illuminate in green,
and mist will disperse from top after a few
seconds. See below the control panel figure
for reference.
2. Adjust the control knob to select desired
mist output level. Rotate knob clockwise
to increase mist output level and counter
clockwise to decrease mist level.
NOTE: High setting will produce the maximum
moisture level and Low setting will produce
the longest run time and quieter performance.
When the humidifier runs out of water, the
transducer and fan will automatically shut off.
3. To stop mist output at any setting, turn the
knob counter clockwise to the off position
4. When the humidifier runs out of water, the
transducer and fan will automatically shut
off. The indicator light will turn red. Turn the
humidifier off and unplug it from the electrical
outlet.
Before refilling, empty any residual water
from the base and the tank (follow the "Daily
Maintenance" instructions). Then follow the
Filling Water Tank Instructions to refill the
tank and put back into the humidifier to begin
operation.
WARNING: DO NOT move the humidifier with
water in the tank or the humidifier base. The
moving action of the water may activate the
water tank's release nozzle and overfill the
humidifier base. This may cause the humidifier
to function intermittently, or stop emitting mist.
If this occurs, simply remove the excess water
from the humidifier base.
LED Night Light
Your humidifier is equipped with blue decorative
night light feature. The light is built in the
humidifier base and below the water tank base,
it can illuminate the water with blue light been
seen from the water level view window. The
decorative light will turn on when the control
knob rotates clockwise into Low to High mist
Indicator Light:
Red: Low Water
Green: Normal
High
Max Mist
.
position, and turns off when the control knob is
placed into Standby position.
NOTE: DO NOT operate the humidifier without
water.
Hygrometer/Thermometer
The Hygrometer/Thermometer included with
your Humidifier operates within the following
specifications:
• Measuring Temperature Range: -50°C ~
+70°C (-50°F ~ +158°F)
• Temperature Accuracy: ±1°C (±2°F)
• Selectable °C or °F Display
• Temperature Display Resolution: 0.1°C
(0.2°F)
• Measuring Humidity Range: 10%Rh ~
99%Rh
• Humidity Accuracy: ±5%
1. Press MIN/MAX key to display the minimum
indoor temperature and minimum indoor
humidity.
2. Press MIN/MAX key again to display the
maximum indoor temperature and maximum
indoor humidity.
3. Clear button (
values.
4. Unit will show a Happy Face - Comfort (
when the humidity level is between 40-60%, a
Sad Face - Dry (
40%, and a Neutral Face - Wet (
humidity level above 60%.
CLEANING AND MAINTENANCE
INSTRUCTION
Humidifiers provide comfort by adding moisture
to dry, heated indoor air. To get the most benefit
from the humidifier and to avoid product misuse,
follow all instructions carefully, specifically the
operation, care and maintenance guidelines.
Please note this is an electrical appliance and
requires attention when in use.
Cleaning your humidifier every one or two
weeks, depending on the water conditions is
important in order to maintain efficient, healthy,
odour-free operation. Water quality varies widely
and, combined with build-up of mineral scale in
your humidifier, may under certain conditions
promote the growth of micro-organisms in the
water tank.
Before cleaning, Please note the
following:
• DO NOT use soap, detergents, abrasives,
gasoline, glass or furniture polish, or boiling
water to clean any part of your Ultrasonic
4
) to reset stored MIN/MAX
) when humidity is below
) for any
)