Festool ETS EC 125/3 EQ Manual De Instrucciones página 11

Switching the extractor signal ON/OFF
The extractor signal is supplied in a deactivated
state.
Switch on power tool by briefly pressing the ON/

OFF button [1-1].
Switch off the power tool again and hold down

the ON/OFF button [1-1].
Power tool beeps once.
Turn speed control [1-2] to both end positions

(Level 1 and 6).
Power tool beeps three times for ON and twice
for OFF.
Release ON/OFF button [1-1].

Extractor signal is activated or deactivated.
The operating mode is indicated via the LED [1-6]:
Replacing the sanding pad [3]
An optimal work result can only be achieved
using original accessories and consumables.
The use of non-original accessories or con-
sumables invalidates the right to claim under war-
ranty.
Warning! Do not perform any structural
changes in the open interior space of the ma-
chine when the sanding pad is dismantled.
Health risk: Fitting sanding pads of incorrect
size causes excessive vibration of the ma-
chine.
Permanent light: Extractor
hose is connected
Flashing light: No extractor
hose connected, power tool
cannot be switched on.
No light: Extractor signal is
not active.
3
Tuned to the surface being processed, the machine
can be equipped with three sanding pads of differ-
ent hardnesses.
Hard: Coarse and fine sanding on surfaces. Sand-
ing edges.
Soft: Universal for coarse and fine sanding, for flat
and convex surfaces.
Extra-soft: Fine sanding of moulded parts, arches,
radii. Do not use on edges.
Attaching sanding accessories using Stick-
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.
4
Fix [4]
11