Setting The Saw Blade Tilt; Sawing With The Rip Fence; Sawing With The Mitre Fence - Elektra Beckum TKHS 315 C Manual De Uso

Adjust cutting height by turning the
handwheel (94) on the chip case.
94
3
Note:
To compensate for possible play
in the blade height setting mechanism,
always raise the blade to the desired
position.
8.3

Setting the saw blade tilt

A
Danger!
Parts of the body or objects in
the setting range can be caught by
the running saw blade! Set the depth
of cut only with the saw blade at
standstill!!
The saw blade tilt is steplessly adjusta-
ble between 0 and 45 .
1. Loosen handwheels at front (95)
and rear of the chip case by approx.
one turn.
2. Set required saw blade tilt.
3. Arrest the set bevel angle by tight-
ening the handwheels.
8.4

Sawing with the rip fence

1. Slide universal fence into the guide
extrusion at the front of the saw.
2. Adopting the fence extrusion to the
workpiece height:
Small edge (96) =
for cutting thin stock
Wide edge (97) =
for cutting thick stock
3. Adjust fence extrusion parallel with
the saw blade and arrest by tighten-
ing knob (98).
4. Set cutting width and arrest with
knob (99).
A
Danger!
Always use the push stick if
the distance between saw blade and
rip fence is less than 120 mm.
95
5. Set the cutting height of the saw
blade. The blade guard must rest
with its front edge on the workpiece.
96 97
6.
7.
8.
9.
8.5
1.
2.
99
98
3.
A
least 10 mm distance to the line of
cut.
4.
5.
6.
7.
8.
9.
ENGLISH
Set and arrest the saw blade tilt.
Start motor.
Cut workpiece in a single pass.
Switch machine off if no further cut-
ting is to be done immediately after-
wards.
Sawing with the mitre
fence
Slide universal fence into the guide
extrusion at the left-hand side of the
saw.
Set required mitre angle and arrest
with knob (100).
101
102 100
Align fence extrusion and arrest in
position with knurled thumb screws
(101).
Caution!
The plastic nose must have at
Tighten knob (102) just enough for
the fence to slide easily on the guide
extrusion.
Set the cutting height of the saw
blade.
Set and arrest the saw blade tilt.
Start motor.
Cut workpiece in a single pass.
Switch machine off if no further cut-
ting is to be done immediately after-
wards.
23