Intended Use; Items Supplied; Appliance Description; Placing/Fixing The Combination Mounting - Balance KH 5525 Manual De Instrucciones

Intended Use

The Hair Straightener is intended for the smoothing
and shaping of human hair, under no circumstances
may it to be used for wigs and hairpieces made of syn-
thetic material. The Hair Straightener is intended for
domestic use only. Pay heed to the information in this
operating manual, especially the safety instructions.

Items supplied

• Hair Straightener KH 5525
• Combination mounting
• 2 narrow ceramic plates
• 2 wide ceramic plates
• Screws
• Wall plugs
• Warranty card
• Operating manual

Appliance description

Control lamp/Viewing window for temperature
q
adjustment
On/Off switch
w
e Power cable with plug
r Rotary controller temperature adjustment
Ceramic plate narrow
t
y Ceramic plate wide
u Securing holes for on-wall assembly
Hair straightner retainer
i
o Retainer for ceramic plates
Combination mounting
a
Placing/Fixing
the combination mounting
You can either securely place the combination
mounting or fix it to the wall.

Setup

Place the combination mounting
and heat resistent surface.

Wall mounting

Danger!
Ensure that there are no electric cables, gas
and water pipelines or other facilities located
underneath the position at which you might
wish to affix the combination mounting
is a risk of receiving an injury or an electric
shock should you bore holes at these posi-
tions!
1. Mark the boreholes on the wall.
To do this hold the combination mounting
the desired position and, with a pencil or a
sharp object, mark the drilling locations
through the securing holes
Take note that the markings need to be made
through the upper, smaller part of the securing
holes u .
2. Bore holes at the marked positions and insert
the wallplugs into them.
3. Turn the screws so far into the wallplugs that
ca. 5 mm of the screwshafts continue to be ex-
posed.
4. Place the combination mounting
screws so that they protrude through the secu-
ring holes u
5. Press the combination mounting
that the screwshafts are now in the narrow part
of the securing holes
6. Tighten both screws down.
- 19 -
a on a level, dry
.
u
a
.
a down so
u .
a
. There
a
at
a
over the