Operation; Preparation; Straightening Hair; Storage - Balance KH 5525 Manual De Instrucciones

Operation

Preparation

Note:
The ceramic plates
mination. If necessary, clean them before taking
them into use (see chapter „Cleaning").
1. Insert the power plug
2.
Press the On/Off switch
lamp q glows.
3. Set the desired temperature with the rotary con-
troller r :
• Temperature from level 1:
fine hair
• Temperature from level 10:
average strength hair
• Temperature from level 20:
strong or difficult to straighten hair

Straightening hair

• Prepare the hair as described in "Before straigh-
tening".
• Start with the lower hair pieces at the back of
the head. Work over the sides to the front.
1.
Separate a ca. 2 cm wide hair strand.
Attention!
Ensure the hair straightener does not make
contact with the skin of the head. Risk of burns!
2. Clamp the hair strand between the ceramic plates
near the head /
t
3.
Pull the whole of the hair strand through the cera-
mic plates t / y in that you pull the hair
straightener downwards.
4. Repeat the process with each individual strand.
5. When all strands have been straightened press
the On/Off switch
extinguishes.
6. Remove the power plug
/ must be free of conta-
t y
into a wall socket.
e
w until the control
and press them together.
y
until the control lamp
w
from the wall socket.
e

Storage

Attention!
NEVER wrap the power cable with plug
around the appliance.
Attention!
ALWAYS remove the power plug
wall socket when the appliance is not in use
and is being stored in the combination moun-
ting .
a
• Always place the appliance in the hair straightener
retainer
i
If the narrow ceramic plates
• Slide the wide ceramic plates
for ceramic plates
• Press the hair straightener together, and place it
in the hair straightener retainer
q
- 21 -
to cool down.
t are assembled:
y in the retainer
o as shown in the illustration.
i .
e
from the
e