Setting Up And Using Your Airline System - Samson Airline 77 Manual De Instrucciones

Setting Up and Using Your AirLine System

Samson AirLine
The basic procedure for setting up and using your AirLine System takes only a few minutes:
1. For your AirLine system to work correctly, both the receiver and transmitter must be set to the same channel. Remove all packing mate-
rials (save them in case of need for future service) and check to make sure that the supplied AP1 receiver and AF1 or AG1 transmitter are set
to the same channel (a complete channel plan is printed on page 59 in this manual). If these channels do not match, contact your distribu-
tor or, if purchased in the United States, Samson Technical Support at 1-800-372-6766.
2. Physically place the AP1 receiver on the ground in front of you. It works best in this position. The general rule of thumb is to maintain
"line of sight" between the receiver and transmitter so that the person using the transmitter can see the receiver.
3. Extend the AP1 antennas and spread the tips horizontally outwards approximately 5 inches.
4. Make sure the Power On-Off switch in your AF1 or AG1 transmitter is set to "Off" and that the 15 dB pad is also Off (switch away from
the direction of the arrow). Pull back gently on the AF1 or AG1 battery cover at the ribbing and pry it upwards to remove it. Please use
care when opening this cover as undue force can damage it. Install a fresh AAA alkaline battery in the battery compartment, being sure to
observe the polarity markings. Then carefully replace the battery cover and gently press down on it until it clicks. Momentarily turn on the
power to the transmitter by sliding its Power on-off switch in the direction of the arrow; the "Power/Battery" LED will flash if the battery is
sufficiently strong (if it lights steadily, the battery has less than 2 hours of power remaining and should be replaced). Once battery strength
is verified, turn the transmitter off again and plug it into your electric guitar or bass.
5. With the Power switch on the AP1 set to the "Off" position (away from the arrow), gently press down on the AP1 battery compartment
latch and swing the battery compartment door open (do not use force when opening or closing the battery door; it is hinged and not
meant to be removed). Install a fresh 9-volt battery, then carefully close the battery door. Alternatively, you can connect a 12-volt AC
adapter (available as an option from your Samson dealer). Turn the AP1 on momentarily to confirm that the battery has been installed
correctly (or that the adapter has been connected correctly); the "On/Battery Low" LED should light green and not red. Then turn the AP1
power off.
12