Guided Tour - Ap1 Receiver - Samson Airline 77 Manual De Instrucciones

Guided Tour - AP1 Receiver

Samson AirLine
2
ON
POWER
BATT. LOW
1
4
∞
LEVEL
AP1
U H F R E C E I V E R
6
OPEN
1: Power switch - Move this switch in the direction of the arrow to turn
3
power to the AP1 on; move it away from the arrow to turn power off. (A
jack must be inserted into the input connector for the receiver to power up.)
2: Power On / Battery Low LED - This LED lights green whenever the AP1
TX
is powered on and it lights red whenever the battery in the AP1 is running
PEAK
low. In order to avoid compromising audio fidelity (or having the AP1 stop
working completely), you should always replace the battery with a fresh
one immediately whenever this LED lights red.
3: TX / Peak LED - This LED lights green whenever the AP1 is receiving
RF signal from a transmitter and it lights red when output signal from the
5
AP1 is at the onset of clipping (that is, when it is on the verge of being
distorted). If you see this light during operation, lower the volume level of
your instrument or switch on the transmitter's 15 dB pad. For more infor-
mation, see the section entitled "Setting Up and Using Your AirLine System"
on page 12 in this manual.
4: Level control - This knob sets the level of the audio signal being out-
put through the AP1 output jack (see #9 on page 6). When using an elec-
tric guitar or bass with an active or high-level pickup, set the knob in the
marked area. For more information, see the section entitled "Setting Up
and Using Your AirLine System" on page 12 in this manual.
4