Publicidad
Idiomas disponibles
Idiomas disponibles
1.Rest theback cavity ofthehood onthewood mounting
strip.
4_5 CAUTION:
Hold
the hood
until
it is
completely
secured
to the wood
mounting strip.
Secure
hood
to wood
strip with (4) screws
#8 - 3/4"
(for
30" and 36" width hoods)
or (6) screws
(for 42" width
hood)
provided
at location
shown.
Drill (2) 3/16"
size
holes
into
the drywall
for wall
anchors
through
the existing
holes
in
the inside
hood
back
in the locations
shown.
Then
install
the (2) wall
anchors
and attach the hood
to these
anchors
with the remaining
#8 - 3/4"
screws
and the (2) washers
provided.
2. Attach
transition
(if required)
to blower
rough-in
plate.
Refer
to page
5 for available
model
numbers.
Use duct tape
to make
all joints
secure
and air-tight.
Model
51600
blower
plate connects
directly
to 7" round duct
without
a transition.
Exterior
blower
model
57745
utilizes
a model
58140
mounting
plate which connects
directly
to 10" round ductwork
without
a transition.
3. Run
power
cable
to installation
location.
Refer
to the
instructions
included
with
the selected
blower
/ rough-in
kit
(sold
separately)
for details
on installing
the rough-in
plate,
install
the rough-in
plate
so that the wiring
box
is
located
on the right
side as you are facing
the hood.
For ducting
through
back
of hood,
remove
existing
plate
from inside
back of hood
and attach
to inside
top of hood
to cover
hole.
Secure
to threaded
studs
with
same
(4)
nuts.
For ducting
through
top of hood,
existing
plate remains
in
place
on inside
back of hood.
Connect
ducting
to transition
or rough-in
plate
as you are
installing
the rough-in
plate.
Use
duct
tape
to make
all
joints
secure
and air-tight.
HD0064
HD0049
HD0063
Top of hood (inside view)
Mounting screw locations
m
m
O}
m
m
m
m
t3
O}
9
m
Publicidad
