First Use Of The Tablet: Connection To The Wi-Fi Network - Promelit ALESSI TAB 2 Manual De Uso

Insert the connector of the power supply in the special seat located in
the lower part of the base, routing the cable through the special slot.
Place then the Tablet on the base (fig. 7), while taking care that the
contacts of the base and the mobile fit well to each other (the red led
located on the frontal part of the Tablet, below the display, must be
switched on).
4 First use of the Tablet: connection to the Wi-Fi
network:
When operating the AlessiTab for the first time, perform the following
operations sequentially:
Verify that your own Wi-Fi router is switched on and that the
1)
wireless network is correctly configured (possibly refer to the user
manual of your own Wi-Fi router).
Connect the network power supply to the Tablet or to the base (see
2)
previous sections).
Set the "ON/OFF" switch located on the rear of the Tablet to
3)
"ON". The switch can later be left set to "ON": to switch the tablet
on/off it is sufficient to use the ALESSITAB² key located on the device.
To switch on the device, keep pressed the front key "ALESSITAB²"
4)
until a grey background appears with the "ALESSITAB²" logo, then
release it and wait until the "Android"™ logo will appear and then
disappear again (NOTE: at the first start-up this process can take
more than one minute).
5
Contacts on the base for recharging
the battery of the Tablet
Fig. 7
Model's User Manual