Domo DO7088S Manual De Instrucciones página 45

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 48
www.domo-elektro.be
will start heating up.
4. When the temperature indicator goes out, the selected temperature has been
reached. You can now start ironing.
Caution: Never touch the hot soleplate!
Steam ironing
Caution: do not plug in the appliance yet at this point.
1. Grab the water tank of the steam generator by the handle and pull the trigger on
the inside of the handle to pull the water tank out of the generator. Open the filling
cap and fill the water tank with water. It is best to use demineralized water. Make
sure that you do not exceed the maximum level (1.2 L). Close the filling cap after
filling the water tank.
2. Place the water tank back into the steam generator.
3. Place the iron on the thermal insulation pads of the steam generator.
4. Plug in the generator, press the on/off button and the light indicator of the lowest
steam level (default) will start blinking. Set the temperature dial to the desired
temperature, according to the kind of fabric, and the temperature indicator will
light up.
5. The water in the water tank will start heating up and after a couple of minutes the
temperature indicator will go out. This indicates
that the soleplate has reached the set temperature.
When the steam level indicator stops blinking and
stays lit up, you can start ironing with steam by
pressing the steam release button.
Attention: make sure that the temperature dial is
positioned into the steam area (indicated by
steam level indicator will keep on blinking and it will not be possible to iron with
steam.
6. You can choose your desired steam level - low (left), medium (middle) or high
(right) - by using the arrows on the control panel. Make sure that there is enough
water in the water tank.
Caution:
Never touch the hot soleplate!
Never aim the steam at people!
7. After ironing, press and hold the on/off button. The appliance will shut off
and all the light indicators will go out. Unplug the appliance. Place the iron on
the thermal insulation pads of the generator and let the appliance cool down
completely.
). If the temperature is too low, the
45
DO7088S

Publicidad

Tabla de contenido
loading

Tabla de contenido