PRINCIPLE OF OPERATION
3
2
1
2
1
OPERATION
Connect the device to the power source.
Before placing cups inside the device, make sure that the layers are dry.
Switch on the device and put the cups inside.
If the device is not used for a long time, it should be completely disconnected from
the power source.
TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when
transported. Store it in a properly ventilated surrounding with dry air and without
any corrosive gas.
CLEANING AND MAINTENANCE
•
Disconnect from electricity when cleaning equipment.
•
Use cleaner without corrosive substances to clean surface.
•
Dry all parts well after cleaning, before the device is used again.
•
Store the unit in a dry, cool location, free from moisture and direct exposure to
sunlight.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be dama-
ged, please stop using it immediately and contact your customer service to solve the
problem.
What to do in case of a problem?
10
1.
ON/OFF switches
2.
layers for the cups
3.
shelf for depositing cups, saucers
Rev. 31.07.2017
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latter is to be found on the technical
plate on the device).
•
If relevant, a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of
the problem if you give a detailed and precise description of the matter. Avoid
formulations like "the device doesn´t heat", which may mean that it doesn´t heat
enough or even not at all. Possibilities like these have different causes!
The more detailed your information, the better the customer service will be able to
solve your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer ser-
vice. This can lead to a loss of warranty!
Rev. 31.07.2017
11