Cycles; Laundry Center Care; Cleaning The Laundry Center Location; Cleaning Your Washer - Kenmore 110.81422 Manual De Uso Y Cuidado, Instrucciones De Instalación

Centro de lavandería de 24" (61 cm) de ancho. lavadora – secadora eléctrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CYCLES

Auto Dry
Use this cycle to dry
most loads. Dryness is
determined by thermostats
that react to the temperature
or amount of moisture
in the air exhausted
from the dryer.
This cycle includes a
5 minute (approximate)
cool down period at the end
of the cycle to make clothes
easier to handle and to reduce
wrinkling.
Use Auto Dry Normal cycle to dry most heavy- to medium-weight
fabrics. When the cycle ends, check the dryness of the load.
If the load is drier than you like, select a setting closer to LESS
the next time you dry a similar load.
If the load is not as dry as you like, complete drying using the
Timed Dry cycle. The next time you dry a similar load, select
a setting closer to MORE.
NOTE: Drying time with an automatic cycle varies according
to the type of fabric, size of load, and temperature setting.
See "Drying, Cycle, and Temperature Tips".
Timed Dry
Use this cycle to complete drying if items are still damp after
the Auto Dry cycle. Timed Dry is also useful for heavyweight
and bulky items, such as bedspreads, work clothes, and large
loads that require a long drying time. Use this cycle to get up
to 50 minutes of heated drying time on 240 volt models, or
up to 110 minutes of heated drying time on 120 volt models.
The heating cycle is followed by a 5 minute (approximately)
cool down period.
Touch Up
Use this cycle to smooth already dry synthetic and permanent
press clothes that are clean but wrinkled from being crowded in a
closet or suitcase. This setting provides approximately 20 minutes
of heated tumbling followed by a 5 minute (approximately) cool
down period. Remove clothes immediately when tumbling stops.
Air Only
Use the Air Only cycle for items that require drying without heat
such as rubber, plastic, and heat-sensitive fabrics. This chart shows
examples of items that can be dried using an air cycle.
Type of Load
Foam rubber – pillows, padded bras,
stuffed toys
Plastic items – shower curtains, tablecloths
Rubber-backed rugs
Olefin, polypropylene, sheer nylon
*Reset time as needed to allow items to completely dry.
When using Air Only
Check that coverings are securely stitched.
Shake and fluff pillows by hand periodically during the cycle.
Dry items completely. Foam rubber pillows are slow to dry.
End of Cycle Signal
Your dryer sounds a signal when a drying cycle is finished.
This signal is helpful when you are drying items that need to be
removed as soon as the dryer stops in order to help keep wrinkles
from forming.
28
240 volt model shown
Minutes*
20–30
20–30
40–50
10–20

LAUNDRY CENTER CARE

CLEANING THE LAUNDRY CENTER LOCATION

Keep the Laundry Center area clear and free from items that
would obstruct the flow of combustion and ventilation air.

CLEANING YOUR WASHER

Cleaning the exterior
Use a soft, damp cloth or sponge to wipe up any spills such as
detergent or bleach. Occasionally wipe the outside of your washer
to keep it looking new.
Cleaning the interior
Keep your washer as clean and fresh as your clothes. To keep
washer interior odor-free, follow this recommended monthly
cleaning procedure:
1. Make sure the washer is empty.
2. Using recommended affresh
to washer basket
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to washer
basket.
IMPORTANT: Do not add detergent. Do not use more than
recommended amount of bleach to avoid damaging product
over time.
3. Close washer lid.
4. Select Heavy Duty cycle, hot temperature, and
Heavy soil level.
5. Pull out the Cycle knob. Water will pour into washer
for a moment and pause, lid will lock, then cycle
will continue.
NOTE: For best results, do not interrupt cycle. If cycle must be
interrupted, push in the Cycle knob.

WATER INLET HOSES

Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges, kinks,
cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
®
washer cleaner, add one tablet

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

110.81432

Tabla de contenido