Taking Weight And Body Fat Readings; Troubleshooting - Tanita UM-028 Manual De Instrucciones

GB

TAKING WEIGHT AND BODY FAT READINGS

After programming your personal data you are ready to take a reading.
1.Tap the ON/OFF Key
The unit will beep and the display will show "0.0". Now step onto the
platform.
Note: If you step onto the platform before "0.0" appears the display will show "Error" and you
will not obtain a reading. Furthermore, if you do not step onto the measuring platform
within about 30 seconds after "0.0" appears, the power is shut-off automatically.
2.Get Your Readings
Your weight will be shown first. Continue to stand on the platform.
"00000" will appear on the display and disappear one by one from left to right.
The readings will be shown alternately 5 times as follows:
Personal data
Do not step off until "00000" disappears.
Note:
Note: Even if you step off the platform after all the result are displayed, the alternating display of Body Weight and Body Fat Percentage will be repeated
5 times. The unit will then shut down automatically.
When a wrong personal number appears, push MEMORY Button until your
personal number appears during measurement.
MEMORY
Note:
SET
• When your data is not stored, push MEMORY Button until "F-1" appears. The unit will
then shut off. Please repeat the steps from "Setting and Storing Data in Memory". (p.5)
• When "F-2" is displayed after measurement, no personal data is stored in the unit.
Please store your personal data before measuring.
6
Weight Body fat percentage

TROUBLESHOOTING

If the following problems occur... then...
• A wrong weight format appears followed by kg, lb, or st-lb
Refer to "Switching the Weight Mode" on p.4.
• "Lo" appears on the display, or all the data appears and immediately
disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will
affect the accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.
Note: Your settings will not be erased from the memory when you remove the batteries.
• "Error" appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
• The Body Fat Percentage reading does not appear or "-----" appears after
the weight is measured.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides
on the measuring platform.
• "OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
• "Error%" appears while measuring.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
GB
7