Before Use - Rimax Baby RB204 Manual De Usuario

User manual
15. This product is not intended for use in wet or damp locations. Never locate the Colour Wireless Monitor
or charger where it may fall into a sink or other water container. When not in use always store in a dry
area.
16. If the supply cord is damaged it must be replaced by the Manufacturer or an authorised service centre
in order to avoid a hazard.
17. Before you dispose of your Colour Wireless Monitor you must remove the batteries and dispose of them
responsibly. Dispose of the batteries and product responsibly.

BEFORE USE

Choose a location
• Choose a location for the camera away from televisions, TV signal boosters and radios. Strong radio
signals generated by these products may cause noise or even retransmitted images on the monitor unit.
If this happens move the camera to a diff erent location.
Connection of Power Supply
• This Colour Wireless Monitor is designed to be powered by either batteries or the provided AC/DC
adaptors. Rechargeable batteries for monitor unit must be charged for at least 8 hours before fi rst use.
Remember to connect provided adaptor with camera unit for power supply.
Install the Camera Stand
Secure the camera unit to the camera stand by tightening the screw on the stand to the bottom of the
camera. Adjust the angle of the camera using the positioning screw at the bottom of the stand.
Using the Batteries:
• The monitor unit requires 3 x AAA size alkaline batteries, or special AAA rechargeable Ni-MH batteries to
operate. Do not use non-approved batteries.
• We recommend the use of the adaptors whenever possible to maintain long term viewing
requirement.
Installing/Removing Batteries:
Monitor:
• Undo the screw and remove the battery cover at the back of the unit.
• Insert the supplied batteries in accordance with marking of the battery compartment.
• Refi t the battery cover and secure with the screws.
• Remember to charge the batteries at least for 8 hours before the fi rst use.
Please note:
• When the power indicator on the monitor unit changes to RED or the video image shrinks, it's time to
change or recharge the batteries.
• Remove the batteries during long period of non-use.
Use AC/DC adaptor:
• Plug the connector of the AC adaptor to the socket on the unit.
• Plug the adaptor into a mains socket.
• Switch on the power switch of the unit.
EN
14
RB-204