GE GBC12IAX Manual Del Propietario E Instalación página 14

REVERSING THE DOOR SWING
TRANSFER FRESH FOOD DOORSTOP
11
AND HOLE INSERTS
A Remove the fresh food doorstop from
the bottom right side of the door.
Remove the hole insert from the bottom right
B
side of the fresh food door.
Install the fresh food doorstop to the bottom
C
left side of the door.
Install the hole insert on the bottom left side
D
of the fresh food door.
Doorstop
Hole
Insert
HANG THE FRESH FOOD DOOR
12
Place the fresh food door onto the center hinge
A
over the pin.
While holding the door in place, raise the top
B
hinge and insert the top pin into the hole in
the door. Swing door shut.
Align the freezer door with the fresh food door
C
so the gap between the doors is even.
D Tighten the top hinge screws by turning them
until snug. Then turn the screws a minimum
of 1/2 turn using both hands.
INSTALL DOOR CAP
13
Remove the insert on the bottom of the door
A
cap with a thin-blade screwdriver.
B Install the insert into the right side
of the door cap.
Installation Instructions
(cont.)
14
INSTALL DOOR CAP (CONT.)
13
Place the top cap onto the top of the fresh food
C
drawer.
Using the screws removed earlier, secure
D
the top cap onto the fresh food door, covering
the end of the hinge.
Screw
INSTALL HINGE COVER AND
14
ELECTRONICS BOX COVER
Remove the tab from the left side of the hinge
A
cover.
Install the tab into the right side of the hinge
B
cover.
Lift up the electronics box cover and place
C
the middle portion of the hinge cover over
the wire harnesses and under the edge
of the electronics box cover. NOTE: Be careful
not to pinch the wiring.
Using the screws removed earlier, attach
D
the hinge cover to the cabinet.
E
Using the screws removed earlier, attach
the electronics box cover to the cabinet.
Screws
Screw
Electronics
Box Cover
Screws
Hinge
Cover