Gima 0476 Manual De Uso página 6

UNPACKING
Always remember that packing elements (paper, cellophane, stitches, adhesive tape,
etc.) can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of
irresponsible persons; the same is valid for tools used to remove packages (scissors,
knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing
the product. Check that they are all present and in perfect conditions.
INSTALLATION
The product is mostly factory pre-assembled. Therefore assembly operations are quite simple
(see illustration):
- Fix the column to the base with the supplied screws
- Connect the connectors to the base of the column
- Insert the altimeter in the seat on the scale's column
- Fix the altimeter in the hole in the plate
- Insert the battery charger plug in the outlet on the side of the panel
- Connect the battery charger to the mains to charge the scale
- Recharge the scale every time the AC indicator lights up
OPERATION
The scale is fitted with an ON/OFF switch. Verify that the switch is set to "1" before any operation.
Before the person steps onto the scale it is necessary to lift the cursor of the altimeter beyond
the apparent height of the person.
After the person has stepped onto the scale, slowly lower the cursor until it touches the head.
Caution: Do not maintain the cursor in horizontal position because it may generate
dangerous situations.
Function of buttons
Selection of weight in kg or lb
kg/lb
Back light function
F
Reset button to set the value to zero or set a tare value
Z/T
by pressing this button, while weighing the person the value is blocked on the display.
HOLD
If the button is pressed again, the button deactivates the function. An indicator shows
when the function is active
ON/OFF ON/OFF switch
- Switch on the scale using the ON/OFF switch, the indicator will run the initialization control and
will show the figures from 000000 to 999999, at the end of the process it will stop in weighing
mode. If the weight on the plate does not correspond to zero, the scale automatically activates
the reset function until it reaches zero. If the scale does not run the operation automatically, it is
necessary to manually adjust or recalibrate the scale.
- If the weight is lower than 2% of the total capacity the ZERO indicator will light up, press Z/T.
SETTING THE AUTOMATIC SHUT OFF FUNCTION AND ADJUSTMENT
- The scale has an automatic shut off function for energy saving purposes and switches off
when it is not used for a few minutes
- Switch the scale on using the «on/off» button
- Press both «Z/T» and «F» to enter the automatic shut off function
- Use «F» to choose after how many minutes (from 1 to 9) the scale will shut off automatically
ENGLISH
6