List Of Error Messages - Gima 0476 Manual De Uso

7
- Press «HOLD» to confirm
- The following message will appear «CAL» (scale calibration)
- Press «HOLD» to confirm or «F» to exit
- Position the maximum weight «200 kg» on the scale
- Enter 200 on the display using «F» to set the value , «kg/lb» to move to the left and «Z/T» to
move to the right
- Confirm with «HOLD»
- If «ERR» appears it means that the value entered for the adjustment of the scale is too low
- If «OF» appears it means that the weight is too high and the scale is in overload

LIST OF ERROR MESSAGES

The A/D value is too low during adjustment
Err1
Overload
—OF—
The zero point is too high when the scale is switched on
O-H
The zero point is too low when the scale is switched on
O-L
Battery low
P-L
MANINTENANCE
The product does not require any special maintenance. The technical life of the scale depends
on its use. Do not use water or liquid products to clean scale, juts use a soft cloth.
Disposal: The product must not be disposed of along with other domestic waste.
The users must dispose of this equipment by bringing it to a specific recycling point
for electric and electronic equipment.
For further information on recycling points contact the local authorities, the local
recycling center or the shop where the product was purchased. If the equipment is
not disposed of correctly, fines or penalties may be applied in accordance with the
national legislation and regulations.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production.
The warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all the
defected parts due to production reasons. Labor costs and personnel traveling expenses and
packaging not included.
All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or
with non-original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due to
outside agents such as: voltage changes, electro-magnetic fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial code (if available)
has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was purchased from.
Products sent to GIMA will be rejected.
ENGLISH