Important Safety Instructions - Makita AT1150A Manual De Instrucciones

ENGLISH
SPECIFICATIONS
Applicable staples
Min. hose diameter
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
IMPORTANT SAFETY INSTRUC-
TIONS
WARNING: WHEN
SAFETY PRECAUTIONS SHOULD ALWAYS BE FOL-
LOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1. For personal safety and proper operation and
maintenance of the tool, read this instruction
manual carefully before using the tool.
2. Always wear safety glasses to protect your eyes
from dust or staple injury. The safety glasses
should conform with the requirements of ANSI
Z87.1.
WARNING:
It is an employer's responsibility to enforce the
use of safety eye protection equipment by the
tool operators and by other persons in the
immediate working area.
3. Wear hearing protection to protect your ears
against exhaust noise and head protection.
Also wear light but not loose clothing. Sleeves
should be buttoned or rolled up. No necktie
should be worn.
4. Rushing the job or forcing the tool is danger-
ous. Handle the tool carefully. Do not operate
when under the influence of alcohol, drugs or
the like.
5. General Tool Handling Guidelines:
(1) Always assume that the tool contains fas-
teners.
(2) Do not point the tool toward yourself or
anyone whether it contains fasteners or
not.
Model
Air pressure
Staple capacity
Net weight
USING THIS TOOL,
370 mm X 87 mm X 290 mm
(14-1/2" X 3-7/16" X 11-3/8")
2.2 kg (4.9 lbs)
USB090-2
(3)
(4)
(5)
(6)
BASIC
(7)
(8)
6. An improperly functioning tool must not be
used.
7. Sparks sometimes fly when the tool is used. Do
not use the tool near volatile, flammable materi-
als such as gasoline, thinner, paint, gas, adhe-
sives, etc.; they will ignite and explode, causing
serious injury.
8. The area should be sufficiently illuminated to
assure safe operations. The area should be
clear and litter-free. Be especially careful to
maintain good footing and balance.
9. Only those involved in the work should be in the
vicinity. Children especially must be kept away
at all times.
10. There may be local regulations concerning
noise which must be complied with by keeping
noise levels within prescribed limits. In certain
cases, shutters should be used to contain
noise.
11. Do not play with the contact element: it pre-
vents accidental discharge, so it must be kept
on and not removed. Securing the trigger in the
ON position is also very dangerous. Never
attempt to fasten the trigger. Do not operate a
tool if any portion of the tool operating controls
is inoperable, disconnected, altered, or not
working properly.
2
AT1150A
65 - 120 PSIG (4.4 - 8.3 bar)
25 mm - 50 mm (1" - 2")
140 pcs.
6.5 mm (1/4")
370 mm X 76 mm X 260 mm
Do not actuate the tool unless the tool is
placed firmly against the workpiece.
Respect the tool as a working implement.
No horseplay.
Do not hold or carry the tool with a finger
on the trigger.
Do not load the tool with fasteners when
any one of the operating controls is acti-
vated.
Do not operate the tool with any power
source other than that specified in the tool
operating/safety instructions.
AT2550A
(14-1/2" X 3" X 10-1/4")
2.3 kg (5.1 lbs)