Dmx-Configuration - JB Systems LED OCTOPANEL Manual De Instrucciones

ENGLISH
 Different working modes:
 Fixed color mode: Instant access to 9 pre-programmed colors
 Static chase mode: 32 different matrix color chases with manual speed control
 Sound chase mode: 32 different matrix color chases with audio triggering
 Spectrum mix: 32 different spectrum mix colors, including color fades
 Adjustable speed and dimming with fader
 Full automatic DMX-address function for up to 16 LED OCTOPANEL units!
 Blackout and "Full on" function
 Overall Dimmer + ultra fast strobe function
4. By CA-8 Easy Controller:
When used in Standalone or Master/slave mode we strongly advice you to use the CA-8 "Easy
controller" Just connect this small controller to the 1/4" jack of the master unit, and you will be able to
control the functions as explained below:
Blackout To blackout all the fixture
Function Strobe Select
9 Colors
1.Synchronous
strobe in white 1. Red
2. Synchronous 2. Green
strobe in rainbow 3. Orange
3. Synchronous 4. Purple
sound in white 5. Yellow
4. Synchronous 6. Cyan
sound in rainbow 7. Magenta
8. Blue
9. White
Sound Latch
Mode
(LED OFF) (LED on)
5. Controlled by universal DMX-controller:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F
balanced cable To prevent strange behavior of the light effects, due to interferences, you must use a
90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!
Each unit in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
 HOW TO SET THE THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (Main menu: DMX-512 address setting) to learn how to set the starting
address on this unit. The starting address of each unit is very important. Unfortunately it is impossible to
tell you in this user manual which starting addresses you have to set because this completely depends
on the controller you will use and also on which channel mode you will select... So please refer to the
user manual of your DMX-controller to find out which starting addresses you must set.
JB SYSTEMS
®
OPERATION MANUAL
Select 11 Setting speed
Show modes
1. Slow speed
1. Show 0 2. Middle speed
2. Show 1 3. Fast speed
3. Show 2
4. Show 3
5. Show 4
6. Show 5
7. Show 6
8. Show 7
9. Show 8
10. Show 9
11. Auto fade
Chase Speed
(LED blink) (LED Fast blink)
7/49 LED OCTOPANEL
ENGLISH
 DMX-CONFIGURATION:
Except for the 24channel mode you must set channels 1 and 2 to value 000 if you want to use color
mixing (setting the channel values "red / green / blue" of the panels yourself ).
JB SYSTEMS
®
OPERATION MANUAL
8/49 LED OCTOPANEL