Using The Xlr Microphone Adaptor - Panasonic LUMIX DMW-XLR1 Manual De Instrucciones

• A commercially available XLR
microphone or microphone
holder can be attached to the
unit's accessory shoe.
∫
Remove the microphone cable
Press the release lever
(1), and hold the plug to
remove it (2).
Using the XLR
microphone adaptor
This unit can be used by turning the power of the digital
camera [ON] while this unit is mounted on the digital
camera.
• The POWER lamp of the unit will turn on.
• The operational sound of the switch operation may be
recorded or the sound may get interrupted, such as when
the switch is operated during the recording of a motion
picture.
∫
Setting the recording level
Set the recording level of audio that is input to the XLR
terminals (INPUT1, INPUT2).
• The recording level of the built-in microphone of the digital
camera and the [MIC] terminal cannot be set.
1
Slide the ALC switch to
[OFF].
2
Rotate the
AUDIO LEVELdial
(INPUT1, INPUT2) to set
the recording level

(volume).

Setting the level while checking with headphones
connected to the digital camera or the digital camera
microphone level display is recommended.
Adjust the recording level automatically.
Slide the ALC switch to [ON]. At high volumes, the
recording level is decreased automatically to reduce
distortion with the sound.
∫
Decrease noise caused by wind or handling
Noise caused by wind or handling is reduced by cutting out
low-frequency components that are input to the XLR
terminals (INPUT1, INPUT2).
Set the LOW CUT switch
(INPUT1, INPUT2) to [16Hz]
or [160Hz].
• Select based on the type of
noise.
7
(ENG) DVQX1208