Product Maintenance; Maintenance; Cleaning; Troubleshooting - Meterman AC71 Manual De Uso

Auto Backlight
The backlight illuminates the entire display for easy measurement
viewing in dark work environments. The backlight activates
automatically in low ambient light conditions.
HOLD Measurements
The HOLD button allows the meter to capture and continuously display
a measurement reading. When the reading has stabilized, press the
HOLD button. The measurement value will be captured on the display.
Press the HOLD button again to release the value.
Hazardous voltages present at test leads may not be
displayed when in HOLD mode.

Product Maintenance

Maintenance

Do not attempt to repair this meter. It contains no user serviceable
parts. Repair or servicing should only be performed by qualified
personnel.

Cleaning

To clean the meter, periodically wipe the case with a soft moistened
cloth. To avoid damage to the plastic components do not use benzene,
alcohol, acetone, ether, paint thinner, lacquer thinner, ketone, or other
solvents to clean the meter.

Troubleshooting

If the meter appears to operate improperly, check the following items
first.
1. Review the operating instructions to ensure the meter is being used
properly.
2. Make sure the battery is in good condition. The low battery symbol
N appears when the battery falls below the level where accuracy is
guaranteed. Replace a low battery immediately.

Battery Replacement

To replace the battery
1. Turn the meter off and remove attached test leads.
2. Loosen the screw and remove the battery door.
3. Replace the battery using an alkaline 9 V battery. See General
Specifications for detailed battery specifications.
4. Replace the battery cover and tighten the screw. Recycle the battery
using approved methods.
To avoid electrical, shock remove the test leads from
both the meter and the test circuit before accessing the
battery.
XWWARNING
XWWARNING
5
See Figure -4-
See Figure -9-
See Figure -10-