Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave
device.
4.
Set up the master device as described in Stand-Alone Mode.
7.4
DMX Mode
This mode allows you to control the device by any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In case of the 7-channel mode, you will have to set the start address of the first unit to 1 (CH1–7),
the second to 8 (1 + 7) (CH8–14), the third to 15 (8 + 7) (CH15–21), and so on. The highest start
address is 506.
To set the device to work with a DMX controller:
1.
Connect the DMX controller to the DMX input of the device.
2.
Press MENU.
3.
Press UP or DOWN until <Addr> is displayed and press ENTER.
4.
Use UP and DOWN to set the DMX starting address (A001–A512) and press ENTER.
5.
Press MENU to quit.
DMX Channel Values
7 channel mode:
Channel
From
1
0
2
0
3
0
4
0
0
5
15
6
0
0
6
7
241
255
8.
Cleaning and Maintenance
All screws should be tightened and free of corrosion.
The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections...
Mechanically moving parts must not show any signs of wear and tear.
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
Disconnect the device from the mains prior to maintenance activities. Let the device cool down.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
Do not immerse the device in any liquid.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
V. 03 – 26/11/2014
VDPLP703RGB
To
Description
255
Main dimmer 100–0 % for channel 2–4
255
Red 0–100 %
255
Green 0–100 %
255
Blue 0–100 %
14
Off
255
Selection of predefined fixed colours
255
Strobe speed slow to fast
5
No function: the device works according to the settings of channel 1–6
240
Fading colours, speed slow to fast
254
Switching colours, speed slow to fast
255
Off
7
©Velleman nv
Publicidad
