Hilti PT 10 Manual De Instrucciones página 17

Symbols
Read the Disposal of
operating power tools
instructions or
before use. appliances
and batteries
together with
household
waste is not
permissible.
2 Description
2.1 Use of the product as directed
The PT 10 is a quick check device that allows a single person to quickly and accurately check whether the accuracy
of a Hilti rotating laser, point laser or line laser is within the specified tolerance. The accuracy of the horizontal laser
beam is checked in each case.
NOTE
Important! Only Hilti laser tools featuring a visible laser beam can be tested.
2.2 Features
This device allows the user to test the laser tool quickly and easily (takes approx. 50 seconds). Operation of the device
is self-explanatory and the result obtained is clear and unequivocal. The PT 10 is compact and robustly built.
The accuracy of the following Hilti laser tools can be checked:
PML 32/ PML 32-R/ PML 42/ PM 2-L line lasers
PM 10/ PM 24/ PMP 34/ PMP 45 point lasers
PR 10/ PR 15/ PR 16/ PR 20/ PR 25/ PR 26/ PRE 3/ PR 35/ PRI 36/ PR 2-HS/ PR 30-HVS rotating lasers
PP 10/ PP 11/ PP 25 pipe lasers
Plus new Hilti leveling and alignment lasers (visible-beam type) from future product generations.
2.3 Settings in accordance with the table of Hilti tools
Hilti laser tool
PM 10/ PM 24/ PMP 34/ PMP 45
PML 32/ PMC/ PMM
PP
PR 10/ PR 15
PR 16/ PRI 2/ PRI 36
PR 20/ PR 28/ PRE 3/ PRE 38/ PR 2-HS
PR 25/ PR 26/ PR 35/ PR 3/ PR 30-HVS
The table of Hilti tools will be updated and replaced when new products are introduced.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
Accuracy class
9
9
1
5
3
1
2
Filter setting
II
I
II
I
I
I
I
en
11