KNK Force SCAL Manual De Usuario página 241

•
Shapes can be located anywhere on the virtual Cutting Mat. The shapes will be moved and aligned to cut
with the origin you set on the material. As mentioned earlier, the origin is set using the position of the blade
tip (or other tool installed on the left side). It is typically set just inside the lower right corner of the material
being cut.
•
When more than one shape will be cut, the shape closest to the origin will be cut at the origin and any other
shapes will be cut the distance and direction from that shape as positioned on the screen. The following
figures show examples of where images will cut. Use the arrow on the Cutting Mat as a guide to the
direction to insert the actual mat or material into your cutter.

Origin Point – Portrait Mode
Indicates Portrait mode
Location of shapes in SCAL

Origin Point – Landscape Mode
Indicates Landscape mode
Location of shapes in SCAL
•
Note that the alignment is based on the bounding box around the shapes:
Feed the mat this direction into the cutter
Where shapes will draw or cut on the material
Feed the mat this direction into the cutter
Where shapes will draw or cut on the material
Shapes are cut to
align with the
origin you set on
the cutter .
Origin set here
Shapes are cut to
align with the
origin you set on
the cutter
Origin set here
241