Audio Pro LIVING LV2 e Manual Del Propietário página 7

COnneCt tO any anOther audiO sOurCe
add mOre lv2e speakers tO the audiO netwOrk
you can add limitless number of lv2e speakers to your system within wireless range of transmitter.
all lv2e spekaers receives wireless signal from transmitter using same house Code.
you can add more speakers to one room, or add speakers in several rooms.
Changing hOuse COde and vOlume ZOne
3
A
use lv2e with lv-suB suBwOOFer
FR
SAT
the tX100 transmitter can be connected to any audio source with
an audio output (e.g. a headset outl). Connect a cable to the audio
source and the audio input on tX100. tX100 is then powered with a
separate usB power supply (available as an extra accessory).
Example: connect to iPad/iPhone dock, Airport Express, TV, radio,
stereo/receiver, mobile phone, network player, NAS, media player.
the rear panel has buttons for changing the house Code and Zone.
push to change the house Code: 1 - 2 - 3, and back to 1.
push to change the Zone: a - B - C, and back to a.
Note: House Code and Zone buttons on the remote control only
show the selected House Code/Zone. Any changes must be made
on the speaker.
lv2e can be used in two modes, satellite or fullrange. the satellite
mode is adapted for use together with living lv-suB. push and hold
both the house Code and Zone buttons for 3 seconds, sat will be
shown in the display. to switch to fullrange, repeat the same proce-
dure. repeat the procedure on both speakers.
Note: In satellite mode, frequencies under 80Hz are disregarded for
LV2e frequency playback. When LV2e is used in satellite mode toge-
ther with LV-SUB, you can play back at a considerably higher volume.
+ +