Simpson 7110274 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect Spray
4
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
Release Air from
7
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30 seconds.
Pull the Recoil
10
Starter Grip
Pull the recoil starter
grip to start the engine.
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the Engine
8
Switch is turned
to the ON
Position
Push the Choke
11
Pin to the
Position
Gradually move the
Choke Pin to the
OPEN Position after
engine starts.
9 - ENG
6
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
9
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
OPEN
Turn Water
Faucet
Completely On
Verify the Choke
Pin is Pulled Out
to the CLOSED
Position

Publicidad

Tabla de contenido
loading

Tabla de contenido