Hitachi CG 22EAS SLP Instrucciones De Manejo página 14

English
Maintenance schedule
Below you will fi nd some general maintenance instructions. For
further information please contact Hitachi Authorized Service
Centers.
Daily maintenance
○ Clean the exterior of the unit.
○ Check that the harness is undamaged.
○ Check the blade guard for damage or cracks. Change the guard
in case of impacts or cracks.
○ Check that the cutting attachment is properly centred, sharp,
and without cracks. An off -centre cutting attachment induces
heavy vibrations that may damage the unit.
○ Check that the cutting attachment nut is suffi ciently tightened.
○ Make sure that the blade transport guard is undamaged and
that it can be securely fi tted.
List of recommended accessories
Type Name
NYLON HEAD
CH-100
(W/NYLON LINE)
NYLON HEAD
CH-100
NYLON HEAD
CH-300
(W/CUTTER
HOLDER CAP)
NYLON HEAD
CH-300
NYLON HEAD
BF-4
NYLON HEAD
BF-5
BLADE
B3/10/2.0
BLADE
B3/12/3.0
BLADE
B4/9/1.6
BLADE
B4/10/1.6
14
Specifi cation
4" Pre-Cut Line 2.2 – 3.0
Manual line
5" 2.2 – 2.7
feed
R M8 x 1.25
4" 2.2 – 3.0
Nut
L M10 x 1.25
5" Nut 2.2 – 3.0
L M8 x 1.25
10" 3
12" 3
9" 4
10" 4
○ Check that nuts and screws are suffi ciently tightened.
○ Check that the unit is undamaged and free of defects.
Weekly maintenance
○ Check the starter, especially the cord and return spring.
○ Clean the exterior of the spark plug.
○ Remove it and check the electrode gap. Adjust it to 0.6 mm, or
change the spark plug.
○ Check that the angle gear is fi lled with grease up to 3/4.
○ Clean the air fi lter.
Monthly maintenance
○ Rinse the fuel tank with gasoline.
○ Clean the exterior of the carburetor and the space around it.
○ Clean the fan and the space around it.
LOOP HANDLE
● ●
● ●
●
●
2.0
3.0
1.6 ●
1.6 ●
BIKE HANDLE
● ● ● ●
● ● ● ●
●
●
● ● ● ●
●
●
● ● ● ●
● ● ● ●
● ●
● ●
●
●
● ●
●
●
● ●
●