Installation - Saber R50SB0417 Manual De Uso

FOR LP GAS CONVERSION:
Conversion to LP gas must be performed by a certified gas technician.
Ÿ
LP Conversion Kit Model A00AA5517 must be used. Specific details for enclosure construction are included
Ÿ
in the conversion kit instructions.
Additional enclosure venting construction is required.
Ÿ
A tank mounting bracket must be added to enclosure (provided with conversion kit).
Ÿ

INSTALLATION

Materials included:
Materials not included:
bracket.
1. Building The Enclosure:
NOTE: If this grill is to be used as a replacement grill in an existing grill enclosure, consult your local contractor to
determine if the grill will work correctly with your existing enclosure.
Consult the table below for enclosure cut-out dimensions.
Four 1/4-20 threaded inserts are located on the bottom of the grill to be used to secure the grill to the enclosure (reference mounting
hole location). It is recommended that only 1/4-20 304 stainless steel fasteners be used to secure the grill in the enclosure.
NOTE: Area directly beneath the grill must be open. No solid surface.
GRILL MODEL
R50SB0417
R67SB0317
Enclosure Enclosure
Top View Top View
Dim. B Dim. B
Cut Out Cut Out
Dim. A Dim. A
10
WARNING
Built-In Grill Unit
Enclosure construction materials, support brackets for built-in unit, fasteners for attachment of support
brackets.
NOTE: ENCLOSURE MUST BE CONSTRUCTED OF NON-COMBUSTIBLE MATERIALS.
Dim. A
28.25"
37.00"
Side
Built- Built-
In In
Unit Unit
Front Front
Dim. B Dim. C
22.00" 9.00"
22.00" 9.00"
Enclosure
Front View
Cut Out
Front
1/4-20 Threaded
Inserts
Dim. D Dim. E
20.25" 27.00"
20.25" 35.63"
Dim. C
Mounting Hole
Dim. D
Location
Bottom View
Dim. E
Of Grill