OPERATING INSTRUCTIONS CONTROL FUNCTIONS
TO ACCESS CONTROL PANEL-
Control panel can be accessed at upper-right corner of insert.
- POWER
The POWER button supplies power to all of the functions
of the fireplace. The POWER button will put the insert in a
standby mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing the
Power button again the unit will turn on at the same
settings.
NOTE:
Holding the POWER button on the control panel for
10 second will disable the heater function.
- FLAME
Each time the flame button is pressed, the intensity of the
flame decreases. There are 5 brightness levels you can
cycle through and the OFF setting.
- HEATER
Your fireplace consists of a fan forced wire element type
heater. The thermostat setting range is 62°F - 82°F or
17°C - 27°C or always ON.
This button on the remote control only turns ON and OFF
heater function.
NOTE:
To change between °F and °C press and hold the
HEATER button on the control panel for 10 seconds.
- TIMER
Press the TIMER button will cycle through the 10 timer
settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H and 9H) and the OFF setting.
- DOWNLIGHT
The downlight button turns on and off the downlight that illuminate inside of the firebox.
Model#
18EF022
23EF022
26EF022
Model#
28EF022
33EF022
18/23/26EF022
REMOTE/REMOTO/
TÉLÉCOMMANDE
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
Figure 4
Figure 5
E-5
Figure 3
28/33EF022
ELECTRIC FIREPLACE REMOTE
TÉLÉCOMMANDE POUR FOYER
INSERTO PARA CHIMENEA REMOTO