Warranty - IKRA HESI 750-1 Hurricane Instrucciones De Manejo

ordering spare parts:
• Type of machine
• Item number of the machine
14. Fault finding
Caution!
Switch off the machine and pull out the mains plug
before commencing fault finding.
The following table shows fault symptoms and describes
how they can be rectified if your machine is not function-
ing properly. If this does not help you localise and rectify
the problem, contact your service workshop..
Cause
Chainsaw does not operate
Chainsaw operates irregularly
Saw chain dry
Chain/guide rail hot
Chainsaw jumps up, vibrates or
does not saw properly
For this electric tool, the company provides the end user - independently from the retailer's obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 60 months beginning from the hand-over of the device which has to be proved by the original
purchasing document. For commercial use and use for rent, the warranty period is reduced to 12 months. Wearing
parts and defects caused by the use of non fitting accessories, repair with parts that are not original parts of the
manufacturer, use of force, strokes and breaking as well as mischievous overloading of the motor are excluded from
this warranty. Warranty replacement does only include defective parts, not complete devices. Warranty repair shall
exclusively be carried out by authorized service partners or by the company's customer service. In the case of any
intervention of not authorized personnel, the warranty will be held void.
All postage or delivery costs as well as any other subsequent expenses will be borne by the customer.
GB | Operating Instructions
Fault
No current supply
Defective outlet
Extension cable damaged
Defective fuse
Mains cable damaged
External loose connection
Internal loose connection
Defective on/off switch
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Saw teeth pulling in the wrong
direction

15. Warranty

14
Remedy
Check current supply.
Try a different source of current,
change as necessary.
Check cable, replace if necessary.
Replace fuse
Take saw to a specialty workshop
Take saw to a specialty workshop
Take saw to a specialty workshop
Take saw to a specialty workshop
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-sharpen or replace chain
Adjust chain tension
Re-sharpen or replace chain
Replace chain
Re-mount saw chain with
teeth in the correct direction