Charging A Stethoset Receiver/ Spare Accupack; Starting The Charging Process; Essential Notes - Sennheiser L 151-10 Instrucciones De Uso

Charging a stethoset receiver/
spare accupack
• Insert the receivers into the
charging compartments of the
L 151-10, the accupacks remain in
the receivers.
• Alternatively, individual
BA 151 spare accupacks can be
charged in small charging
compartments integrated into the
side of the main charging
compartments for the receivers.
However, it is only possible to
insert either an individual
accupack or a receiver containing
an accupack into the charging
compartment (not both
together).

Starting the charging process

By pressing the button, the „normal"
charging process begins. The red LED
goes off briefly and the charging
process is indicated by the red control
LEDs at the occupied charging com-
partments. The automatic charging
process (timer-controlled) will be
completed after 8 hours. The device
then switches to trickle charging.

Essential notes

• The charging process („CHARGE") cannot be interrupted. By pressing the button again,
the charging timer is reset and the charging process starts over again.
• A power failure also resets the charging timer and the charging process starts
over again.
• Switch off the receivers before starting the charging process! For additional
information on the use of the receivers, please refer to the corresponding operating
instructions.
• Place the charging unit on a flat surface in order that the contacts of the receivers
are securely connected to the charging unit.
8