Preparing Electrical Connections; Wiring Diagrams; Installing Ductwork - Haier HHX6130 Manual Del Usuario

English
Ductless – In ductless installations, air is vented back into the kitchen through the opening in
the range hood grille. If you do not anticipate heavy
cooking, this method may be preferable. Ductless
installation requires the use of a charcoal filters (included)
to remove odors, which should be replaced at regular
intervals depending on use. Check with your local retailer
or dealer for replacements. For ductless discharge do
not remove A or B.
Note: This charcoal filter is not dishwasher safe!
Preparation of Electrical Connections
Note: If replacing an existing hood, the electrical cable may need to be re-routed to
the desired position.
1. Determine the location of the electrical cable to connect to the range hood (Fig. 2). The
preferred location for the electrical connector, vertical or horizontal, will depend on the
existing installation or ease of routing wiring. All electrical connections must comply with
national and local codes. Transfer the location of the selected range hood knockouts
to the bottom of the cabinet or onto the wall, then cut or drill a hole to allow for
clearance of the electrical cable clamp. Be careful not to cut into any hidden utilities,
such as electrical wires.
2. Once you have planned your ducting and electrical installation, remove the appropriate
electrical knockouts on the back or top of the range hood, attach the damper frame
and install a standard electrical cable clamp.
7