Maintenance And Cleaning - Krampouz GGCIC30AA Instrucciones De Uso

1. Heat up the burner in the maximum position for 3 to 4 minutes
2. Place the knob in the small flame position.
3. Remove the knob by pulling it towards you.
4. Using a small screwdriver, you can now access the adjustment screw on the tap shaft end.
5. Watching the flame under the plate, loosen the screw to increase the low heat and tighten it to
reduce it.
6. Put back the knob adhering to the orientation of the flat surface on the shaft of the tap.
Spark plug of piezo
To ensure correct ignition of the burner, the plug must always be positioned at 5 mm from the burner
(see figure 5, page 18).
Thermocouple safety device
To ensure correct operation of the thermocouple safety device, the end must be in the flame and must
always be positioned 2 mm from the burner (see figure 6, page 18).

Maintenance and Cleaning

Frame:
To avoid burns, you are advised to always allow the hot plate to cool down before cleaning the
frame. Clean with a sponge soaked in warm water and detergent. Never use abrasive products or
metal brushes.
Hot plate:
When cold, pour a glass of cold water or ice cubes on it and scrape off residue with a scraper.
Burner:
Check the condition of the flame holes on the burners from time to time. If they are blocked, brush the
arms with a stiff bristled brush. Before starting back up, wipe the burners thoroughly along with the
base of the plancha. To clean the injectors, you are strongly advised against using metal objects as
these could alter the technical specifications of the burners. You are therefore advised to take down
the injectors referring to chapter: Adjustments, page 15. Then soak them in a degreasing solution,
rinse and dry thoroughly. You are advised to change the seal on every dismantling operation.
Warning
To ensure correct operation, appliances must compulsorily be fitted with the hot plate manufactured
by KRAMPOUZ.
- 16 -